Standard Shipping to
- 38% DC DC 12v-36v 500w Brushless Motor Drive Controller Board with Hall Motor Balance Car Drive
DC DC 12v-36v 500w Brushless Motor Drive Controller Board with Hall Motor Balance Car Drive DC DC 12v-36v 500w Brushless Motor Drive Controller Board with Hall Motor Balance Car Drive DC DC 12v-36v 500w Brushless Motor Drive Controller Board with Hall Motor Balance Car Drive DC DC 12v-36v 500w Brushless Motor Drive Controller Board with Hall Motor Balance Car Drive DC DC 12v-36v 500w Brushless Motor Drive Controller Board with Hall Motor Balance Car Drive

DC DC 12v-36v 500w Brushless Motor Drive Controller Board with Hall Motor Balance Car Drive

$16.82

Dispatch: Ship within 1-3 days
Shipping: US $3 to via Standard Shipping
Estimated Delivery: 8 - 22 business days
SKU: 1939264 Category:
Added to wishlistRemoved from wishlist 0

Buy DC DC 12v-36v 500w Brushless Motor Drive Controller Board with Hall Motor Balance Car Drive wholesale price

Specification:
Working voltage: DC 12V-36V
Working current: <=15A
Driving power: <=500W
Speed ​​voltage: 0.1V-5V
Working temperature: -40-85C
Humidity: 90% Rh
Stall Protection: Yes
Enable Control: Yes
Overcurrent Protection: Yes
Steering Control: Yes
Speed ​​control signal: yes
Size: 63*42*17mm (length*width*height); probe size is 3mm, length: the center distance of the fixed hole is 57mm; width: the center distance of the fixed hole is 36.5mm
Power terminal output:
MA (motor phase U)
MB (motor phase V)
MC (motor phase W)
GND (negative supply)
VCC (positive supply)
Set for the control side:
5V: 5V output
EL: enable control terminal (ground 5V OT ground, then ground 5V, motor stops)
Signal: Tachometer pulse output (depending on the number of motor poles corresponding to the number of pulses per revolution of the output digital)
Z/F: reversing control (connect to 5V or ground to charge the motor in the direction of rotation)
VR: regulator end 0-5V (corresponding to 10% motor speed -100%)
GND: Ground control terminal
Hall interface:
5 volts, the positive pole of the Hall power supply
HA, Hall signal A/U
HB Hall signal B/W
HC Hall signal C/W
Ground, Hall Negative
Install the wires:
Unit control terminal:
1. Motor speed control wiring method: the system speed of the available potentiometer can also be connected to the microcontroller for control. When the potentiometer controls the wiring, the middle pin of the potentiometer is connected to the VR speed port, the two ends of the potentiometer are connected to 5V, the ground terminal voltage is faster, and the speed faster.
2. Motor steering control wiring method: You can also connect the switch control to the microcontroller control, ground in one direction, and then 5V in one direction.
Pulse speed signal: high and low output. IC cannot understand the information requested by the client
Hall signal input:
The wiring diagram is as shown, one of them corresponds to HA, HB, HC, on the motor, the 5V power signal connected to the motor HAL is positive, and the ground power signal is negative, connected to the motor hall.
Note: Due to different motor manufacturers, ordering of hall lines does not have to match the order of lines on the circuit board, it needs to be adjusted, please pay attention! If the circuit sequence is wrong, it cannot be started correctly, the current or other phenomena cannot be turned on, and the forced use of the drive disk will burn out! ! ! !
Motor driver board 12-36V DC power input, VCC positive power supply, GND negative power supply
Electrical wiring: three-wire brushless DC motor, corresponding to MA/U, MB/V, MC/W
Tip: If the heat sink you use is less than 60W and there is no additional heat sink, be sure to add a heat sink of more than 60W. Without reducing the driving efficiency of the heat sink, excessive temperature will cause permanent damage! The size of the heatsink may be based on harsh environment work (recommended cooling area greater than 200 cm2)! When installing the radiator, be sure to pay attention to the insulation of the MOS tube on the back of the module. If there is no insulation, it will stick to the driver board and be permanently damaged! It is recommended to add thermal insulation film, and add thermal insulation board heating grease on both sides!
Package includes:
1 x Brushless Motor Drive Controller Board

Best DC DC 12v-36v 500w Brushless Motor Drive Controller Board with Hall Motor Balance Car Drive factory direct price

Specification: DC DC 12v-36v 500w Brushless Motor Drive Controller Board with Hall Motor Balance Car Drive

Weight 0.03 kg

User Reviews

0.0 out of 5
0
0
0
0
0
Write a review

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

RECENT PRODUCT REVIEWS
  1. Its very good item for me, usually I am using this for charging my power bank (10000mah). Very good.

  2. Excellent android box

    I bought one for us. And to be honest I was VERY SCEPTICAL. But once installed the sky is the limit on what you can do. Our kids are grown with their own children and even the grandchildren know how to operate it and love the video options. So we decided to get them their own and not to brag but mom and dads gift were the bomb. Even the grandchildren were excited 

  3. A+ If you use the right cup!

    After having it for a few days I love it! I tried it with different cups and mugs and you’ll want to use the a mug with a flat base to really spread the heat. I pre heat my mug while my coffee brews and it will stay hot as long as you’d like. I found the default high heat setting worked best for me. It’s not to expensive and makes a great gift. I got mine in black and it looks great on my desk at work.

  4. Yes, it works!

    This thing really works. If you are reading a review that says it doesn’t then they r either not using it correctly or using the wrong product. I did not get paid to use this product or my personal opinion like others. I didn’t want to spend all the extra money on a fancy brand name with the same results. My pics will speak for themselves. 

  5. Perfect nothing to say and accurate data super
    Thanks to seller send fast

  6. Lightly box is pressed in brightness, but writing data is no problem four yo ~

  7. Arrival a few days before the scheduled date, very satisfied. Well packaged, received intact and functional, perfect for sketches, simple design but good for the price. Comes with an anti-loss strap, and the pen easy to store.

  8. I arrived a week earlier than planned, I loved it coming with the battery included, very good product

  9. It didn’t take long to get there, all ok

DC DC 12v-36v 500w Brushless Motor Drive Controller Board with Hall Motor Balance Car Drive

$16.82

Pricetug
Logo
Reset Password